Manufacturer's Name Emergency Telephone Number Telephone Number for Information
1500 Oakdale Ave., Toledo, Ohio 43605 - 129 Lockwood St., Newark, NJ 07105
Section 2 - Hazardous Ingredients/Identity Information
Hazardous Components OSHA PEL ACGIH TLV Other Limits Recommended % (optional) Non-hazardous Hazardous Material Identification System (HMIS): Health - 0, Flammability - 1, Reactivity - 0 Not a Controlled Product under (WHMIS) - Canada Special Protection: See Section 9 Section 3 - Health Hazard Data
Threshold Limit Value
mg/m3 for oil mist in air. OSHA Regulation 29 CFR 1910.1000
Effects of Overexposure Prolonged or repeated skin contact may cause skin irritation. Product contacting the eyes may cause eye irritation. Human health risks vary from person to person. As a precaution, exposure to liquids, vapors, mists and fumes should be minimized. This product has a low order of acute oral toxicity, but minute amounts aspirated into the lungs during ingestion may cause mild to severe pulmonary injury. Carcinogenicity: Section 4 - Emergency and First Aid Procedures
EYE CONTACT: Flush with clear water for 15 minutes or until irritation subsides. If irritation persists, consult a physician. SKIN CONTACT: Remove any contaminated clothing and wash with soap and warm water. If injected by high pressure under skin, regardless of the appearance or its size, contact a physician IMMEDIATELY. Delay may cause loss of affected part of the body. INHALATION: Vapor pressure is very low and inhalation at room temperature is not a problem. If overcome by vapor from hot product, immediately remove from exposure and call a physician. INGESTION: If ingested, call a physician immediately. Do not induce vomiting. Section 5 - Fire and Explosion Hazard Data Flash Point (Method Used) Flammable Limits
Extinguishing Media
Foam, Dry Chemical, Carbon Dioxide or Water Spray (Fog)
Special Fire Fighting Procedures
Cool exposed containers with water. Use air-supplied breathing equipment for
Unusual Fire and Explosion Hazards
Do not store or mix with strong oxidants. Empty containers retain residue.
Do not cut, drill, grind, or weld, as they may explode.
PRODUCT NAME OR NUMBER - LUBRIPLATE Lithium Brick Grease Section 6 - Physical/Chemical Characteristics
Boiling Point Specific Gravity (H 2O = 1) 0.89
Vapor Pressure (mm Hg.) <0.01 Melting Point
Vapor Density (AIR = 1) >5 Evaporation Rate (Butyl Acetate = 1) Solubility in Water
Appearance and Odor
Very firm blocks of grease, amber color with mineral oil odor.
Section 7 - Reactivity Data Stability Unstable Conditions to Avoid N/A Incompatibility (Materials to Avoid)
Avoid contact with strong oxidants like liquid chlorine, concentrated oxygen.
Hazardous Decomposition or Byproducts May form SO 2. If incomplete combustion, Carbon Monoxide.
Hazardous Polymerization May
Occur Conditions to Avoid N/A Section 8 - Spill or Leak Procedures Steps to be taken in case material is released or spilled Scrape up grease, wash remainder with suitable petroleum solvent or add absorbent. Keep petroleum products out of sewers and watercourses. Advise authorities if product has entered or may enter sewers and watercourses. Waste disposal method Assure conformity with applicable disposal regulations. Dispose of absorbed material at an approved waste disposal facility or site. Section 9 - Special Protection Information
Respiratory Protection (Specify type)
Ventilation Local Special N/A Mechanical (General) Other N/A
Protective Gloves Use oil-resistant gloves, if needed. Eye Protection If chance of eye contact, wear goggles.
Other Protective Equipment Section 10 - Special Precautions
Precautions to be taken in handling and storing Keep containers closed when not in use. Do not handle or store near heat, sparks, flame, or strong oxidants. Other Precautions Remove oil-soaked clothing and launder before reuse. Cleanse skin thoroughly after contact. The above information is furnished without warranty, expressed or implied, except that it is accurate to the best knowledge of Fiske Brothers Refining Company. The data on these sheets relates only to the specific material designated herein. Fiske Brothers Refining Company assumes no legal responsibility for use or reliance upon this data.
Date Prepared: January, 2006 Prepared by: James R. Kontak
LUBRIPLATE